Solving Problems
6.
4
2
To remove the jammed paper, open the rear cover.
3
Carefully remove the paper by pulling in the direction as
shown below. Most of the jammed paper can be removed
in this step.
If you cannot find the jammed paper, or if there is any
resistance removing the paper, stop pulling and go to the
next step.
N
OTE
: If the paper tears, make sure that all of the paper
fragments are removed from the printer.
4
Close the rear cover and then open the top cover.
5
Holding the inner cover open, carefully take the jammed
paper out of the printer. The inner cover will then close
automatically.
C
AUTION
:
Do not touch the fuser inside the inner cover. It is hot
and could cause burns! The fuser’s operating temperature is 180
°C (356 °F). Take care when removing paper from the printer.
6
Close the top cover. Make sure that it is securely closed.
7
Open and then close the rear cover or front cover to
resume printing.
Summary of Contents for Phaser 6110
Page 1: ......
Page 49: ...Software section ...