www.zinetic.co.uk
www.zinetic.co.uk
email:
sales@zinetic.co.uk
Shake your bottle
of new toner
vigorously for 20
seconds
BEFORE
removing the cap.
Remove cap and
seal.
Fit the toner pouring
spout securely to
the bottle.
Screw it down as
tight as it will go.
Wrap any type of tape around the base of the
spout & neck of the bottle to prevent any fine
toner powder escaping.
Carefully
insert the spout
into the hole
.
(The toner will flow out like water, so take care
not to spill it)
There is a lot of toner to get into the
cartridge this will take approx. 5 minutes.
Don’t rush this part.
With the spout inserted –
carefully “
Upend” the
cartridge and allow the toner to slowly pour down
and into the cartridge.
The toner port will be at the top nearest the
ceiling so that gravity will help move the toner
down inside the cartridge.
