03/01
6-5
Phaser 790/DocuColor 2006
GP 2
General Procedures and Information
Output Codes
WARNINGS and CAUTIONS
WARNING
In the following section hazardous conditions may exist while executing some of the
Digital Output routines. Review all WARNING messages (
Table 2
) before proceeding!
CAUTION
To avoid machine damage, review all Caution messages (
Table 2
) before proceeding.
The DO TEST diagnostic menu selection allows the technician to drive selected parts, such as
solenoids, clutches, and motors to assist in the diagnosis and repair of problems. Some codes
activate components for a limited duration or for a single cycle; other codes leave the compo-
nent active until switched off. Refer to
Table 3
for details.
82
+24 VDC to MCU PWB
Not used
--
83
Duplex Option
Ready
3.5
84
Turn Chute Interlock
Turn Chute Closed (L) +5 VDC
1.3
85
Fuser Fan
Fuser Fan Fail (H) +5 VDC
10.3
86
Exit Chute Fan
Exit Chute Fan Fail (H) +5 VDC
10.3
87
Developer Fan
Fan Alarm
9.4
90
Inverter Sensor
Sheet at Inverter Sensor (L) +5 VDC
10.5
91
Duplex Entrance Sensor Duplex Entrance Sensor (L) +5 VDC
10.5
92
Duplex Exit Sensor
Duplex Exit Sensor (L) +5 VDC
10.5
93
Cab Interlock
Cab Interlock Closed (L) +5 VDC
1.5
94
Duplex Tray
Duplex Tray Set (L) +5 VDC
10.7
95
+24 VDC to Optional
Duplex
Not used
--
96
Inverter Motor
Inverter Motor Fail (H) +5 VDC
NOTE: Stack with DO code A0
10.8
A0
Low Paper Sensor Tray 2 Low Paper Sensed (H) +5 VDC
A4
No Paper Sensor Tray2
No Paper Sensed (H) +5 VDC
7.3
A5
Nudger Sensor Tray 2
Nudger Sensed (L) +5 VDC
7.3
A6
Feed Out Sensor Tray 2
Paper Feed Out Sensed (L) +5 VDC
8.3
B0
Low Paper Sensor Tray 3 Low Paper Sensed (H) +5 VDC
7.4
B4
No Paper Sensor Tray 3
No Paper Sensed (H) +5 VDC
7.4
B5
Nudger Sensor Tray 3
Nudger Sensed (L) +5 VDC
7.4
B6
Feed Out Sensor Tray 3
Paper Feed Out Sensed (L) +5 VDC
8.4
C0
Feeder Right Cover
Interlock 1
Feeder Right Cover Interlock 1 Closed
(L) +5 VDC
1.4
C1
Feeder Right Cover
Interlock 2
Feeder Right Cover Interlock 2 Closed
(L) +5 VDC
1.4
C2
+24 VDC to Optional
Feeder
Not used
--
C3
Feeder Motor
Feeder Motor Fail (H) +5 VDC
NOTE: Stack with DO code B8
8.5
D0
Sorter Full Sensor
Paper Sensed (L) +5 VDC
11.3
D1
Sorter Path Sensor
Paper Sensed (L) +5 VDC
11.3
D2
Sorter Top Cover Inter-
lock
Sorter Top Cover Interlock Closed (H)
+24 VDC
11.1
D3
Bin Home Switch
Bin Home Switch Closed (L) +5 VDC
11.4
D4
Bin Cam Switch
Bin Cam Switch Closed (L) +5 VDC
11.4
D5
Docking Interlock
Docking Interlock Closed (L) +5 VDC
11.1
D6
Receiver Sensor
Paper In Bin Sensed (H) +5 VDC
11.3
Table 1 Digital Input Codes
DI Code
Component
Signal
BSD Ref
Table 2 Warnings and Cautions
Warning or Caution
Message
WARNING
When high voltages are generated, do NOT touch any output section
or conducting (live) section where high voltages may be present
WARNING
When the drive section is active, do NOT touch the drive section.
WARNING
When the laser beam is generated, ALWAYS install all covers
CAUTION
To avoid fatigue caused by electric charge, do NOT switch ON the
BCR, the ERASE LAMP ASSY, or the LD on the ROS ASSY when the
PROCESS MOTOR ASSY is switched OFF
CAUTION
To avoid damage to the IBT BELT ASSY, do NOT switch ON BTR 1
when the PROCESS DRIVE ASSY is switched OFF
CAUTION
To avoid damage to the IBT BELT ASSY, do NOT switch ON BTR 2
when the PROCESS DRIVE ASSY and the FUSER-P/H MOTOR are
switched OFF
CAUTION
To avoid smear to the printer or damage to gears caused by misen-
gagement, do NOT switch ON the FUSER-P/H MOTOR or the DEV.
CLUTCH ASSY at positions offset from those where each color is
developed
CAUTION
To avoid damage, do not energize codes for longer than is required to
test the component(s)
Summary of Contents for Phaser 790
