03/01
6-6
Phaser 790/DocuColor 2006
GP 2
General Procedures and Information
NOTE: In the digital output test mode, each component is actuated using the DO TEST menu
and deactuated using the STOP DO TEST menu. Therefore, to deactuate an actuated compo-
nent, you must first go back to the STOP DO TEST menu and select the component again. If
multiple codes are stacked, components should be deactivated in the sequence in which they
were switched on.
The following table lists the digital output codes.
Table 3 Digital Output Codes
DO Code
Component
Signal
BSD Ref
00
Process Drive Unit
NOTE: see
WARNINGS and CAUTIONS
Process Motor Speed 0 (half-speed)
Stack with DO code 54
9.2
06
Process Drive Unit
NOTE: see
WARNINGS and CAUTIONS
Process Motor Speed 1 (1/3rd speed)
Stack with DO code 54
9.2
07
Optional Feeder
Start Signal
Check signal state with DMM (refer to BSD
3.4 for connection)
3.4
08
Optional Feeder
Start Signal
Check signal state with DMM (refer to BSD
3.4 for connection)
3.4
09
Duplex Option
Start Signal
Check signal state with DMM (refer to BSD
3.5 for connection)
3.5
0A
HVPS
NOTE: see
WARNINGS and CAUTIONS
.
Function not currently supported
BTR 2 Bias On (L) +24 VDC
9.7
0B
HVPS
NOTE: see
WARNINGS and CAUTIONS
.
Function not currently supported
BTR 1 Bias On (L) +24 VDC
9.6
0C
HVPS
NOTE: see
WARNINGS and CAUTIONS
.
Function not currently supported
Developer DC Bias On (L) +24 VDC
9.4
0D
HVPS
NOTE: see
WARNINGS and CAUTIONS
.
Function not currently supported
Developer AC Bias On (L) +24 VDC
9.4
0E
HVPS
NOTE: see
WARNINGS and CAUTIONS
.
Function not currently supported
BCR DC On (L) +24 VDC
9.1
10
Rotary Motor
Rotary Motor Low Speed On (L) +5 VDC
Check signal state with DMM (refer to BSD
9.3 for connection)
9.3
11
Rotary Motor
Rotary Motor On (L) +5 VDC
Check signal state with DMM (refer to BSD
9.3 for connection)
9.3
17
Exchange Solenoid
Exchange Solenoid Push (L) +24 VDC
10.4
18
Exchange Solenoid
Exchange Solenoid Pull (L) +24 VDC
10.4
19
Inverter Solenoid
Inverter Solenoid Push (L) +24 VDC
10.5
1A
Inverter Solenoid
Inverter Solenoid Pull (L) +24 VDC
10.5
1B
Feed Solenoid
Feed Solenoid On (L) +24 VDC
8.1
1C
Turn Clutch
Turn Clutch On (L) +24 VDC
8.1
1E
Registration Clutch
Registration Clutch On (L) +24 VDC
8.7
1F
Preregistration Clutch
Preregistration Clutch On (L) +24 VDC
8.7
20
Bypass Tray Feed
Clutch
Feed Clutch On (L) +24 VDC
8.2
21
Developer Clutch
NOTE: see
WARNINGS and CAUTIONS
Developer Clutch On (L) +24 VDC
9.4
22
MCU PWB
Not used
--
23
Lift Motor
NOTE: see
WARNINGS and CAUTIONS
Requires input of a directional code (DO-2D
or DO-2E) to activate.
Limited duration (.12 sec)
7.2
2D
Lift Motor
NOTE: see
WARNINGS and CAUTIONS
Requires stacking with DO-23 to activate.
Limited duration (.12 sec)
7.2
2E
Lift Motor
NOTE: see
WARNINGS and CAUTIONS
Requires stacking with DO-23 to activate.
Limited duration (.12 sec)
7.2
3A
MCU PWB
Function not currently supported
--
3C
MCU PWB
Function not currently supported
--
3F
MCU PWB
Function not currently supported --
44
ROS
Function not currently supported
--
46
MCU PWB
Function not currently supported
--
47
Heat Roll Heat Lamp,
Pressure Roll Heat
Lamp
NOTE: see
WARNINGS and CAUTIONS
Heat Roll Heat Lamp, Pressure Roll Heat
Lamp On (L) +5 VDC
Limited duration (.12 sec)
10.2
4C
MCU PWB
Function not currently supported
--
52
Paper Handling Motor
Function not currently supported
--
53
Fuser Motor, Paper
Handling Motor
NOTE: see
WARNINGS and CAUTIONS
Motor On (L) +5 VDC (full speed unless
stacked with code DO-57 or DO-62)
4.1
Table 3 Digital Output Codes
DO Code
Component
Signal
BSD Ref
Summary of Contents for Phaser 790
