4 - 130
Phaser 840/850/860/8200 Color Printer - Service Manual
Test ID#
R#
Definition
Results
Interpretation/Actions
Paper Path Timing
ID# 4
(cont’d)
9
Duplex feed clutch
to width A4 flag
> 220
Media was not deskewed
successfully. Ensure proper tray
loading and verify front door
deskew fingers are not damaged.
This may also be due to a bad
feed clutch, slippery feed roller or
misaligned sensor.
< 180
10
Duplex width A4
flag to preheat exit
flag
> 180
Media was not deskewed
successfully. Ensure proper tray
loading and verify front door
deskew fingers are not damaged.
This may also be due to a bad
feed clutch, slippery feed roller or
misaligned sensor.
< 160
11
Preheat exit flag
to strip exit flag
> 730
The media was delayed in
reaching the strip sense flag.
Light weight or coated media
may tend to stick to the transfix
roller. This may also occur if the
transfix roller is dirty or not
properly oiled. The rapid release
guide may also be bound or
damaged.
12
Strip exit flag to
paper exit flag
> 150
Something may be obstructing
the exit path.
Paper Path Drive (Test ID # 5)
- This test runs successive pieces of paper through the media
path at low current levels to determine the minimum drive current. Due to the nature of the test
the last sheet results in a paper jam, and in some cases causes engine firmware to halt. By
counting the number of sheets that were tried, including the sheet that jammed, you can
interpret the test results (number of sheets is equal to scan cycles).
Test ID#
R#
Definition
Results
Interpretation/Actions
Paper Path Drive
ID# 5
0
% drive current at
end scan
> 74.7
Inspect the paper path drive
components engaged at the time
of the paper stall for binding or
wear.
1
Scan cycles
> 4
Inspect the paper path drive
components engaged at the time
of the paper stall for binding or
wear.
2
Leading edge
sensor id
Sensor ID Codes:
0 = None
9 = Stripper Exit
1 = Aux2 Pick
10 = Exit
2 = Aux1 Pick
11 = Duplex Entry
3 = Std Pick
12 = Duplex Width A
4 = Handfeed
13 = Duplex Preheat Entry
5 = Width A
14 = Duplex Width A4
6 = Preheat Entry 15 = Duplex Preheat Exit
7 = Width A4
16 = Duplex Stripper Exit
8 = Preheat Exit
17 = Duplex Exit
3
Trailing edge
sensor ID
Table 4-4 Check Menu Value Key
Summary of Contents for Phaser 840
