10.
Remove frame assembly. (PL 5.6B)
a.
Disconnect P/J109 and P/J111 (RX only) from main PWB.
b.
Remove E-ring from front of hinge shaft, and remove bearing
(Figure 7).
Figure 7. Printer frame removal
7033-253
Bearing
E-ring
Bearing
E-ring
c.
Remove E-ring from rear of hinge shaft, and remove bearing
(Figure 7).
d.
Pull printer cover frame assembly away from terminal.
11.
Remove secondary pulley (22T). (PL 5.6A)
a.
Remove E-ring from front of hinge shaft, and remove front
bearing (Figure 7).
b.
Remove E-ring from rear of hinge shaft, and remove bearing
(Figure 7).
c.
Remove two inner bearings from hinge shaft.
Figure 8. Pulley removal
Set screw
Bearing
Secondary
pulley
Hinge shaft
7033-254
d.
Remove belt from secondary pulley.
e.
Loosen set screw in pulley.
f.
Slide shaft to the front until it clears the rear of printer frame,
keeping the rear shaft core and spring in place.
g.
Remove bearing from end of shaft.
h.
Remove pulley from shaft.
8/91
4.4 Upper Printer Assembly
4-26
Telecopier 7032 / 7033 Service Manual
www.printcopy.info
www.printcopy.info
Summary of Contents for Telecopier 7032
