1-8
Getting Started
To connect the WorkCentre 490cx to a computer using a parallel
cable, follow the steps below:
CAUTION: Make sure the computer is turned off, and the WorkCentre
490cx is unplugged from the power outlet.
1
Plug the parallel cable into the connector on the back of the
WorkCentre 490cx. Swing the metal clips of the connector inward until
they lock firmly inside the notches on the parallel cable connector.
2
Connect the other end of the cable to the parallel port on your computer.
Refer to your computer documentation for assistance with this
procedure.
Close Cable
Connector
Locking Clips
Summary of Contents for WorkCentre 490cx
