Network Configuration
WorkCentre 5300 Series Multifunction Printer
System Administrator Guide
30
Raw TCP/IP Printing
Raw TCP/IP is a printing method used to open a TCP socket-level connection over Port 9100, to stream
a print-ready file to the printer's input buffer. It then closes the connection either after sensing an End
Of Job character in the PDL or after expiration of a preset time-out value. Port 9100 does not require
an LPR request from the computer or the use of an LPD running on the printer. Port 9100 is selected in
Windows as the Standard TCP/IP port.
Enabling Port 9100
Note:
TCP/IP must be enabled before Port 9100 is enabled.
1.
In CentreWare IS, click
Connectivity
>
Port Settings
.
2.
Next to
Port 9100
, select
Enabled
.
Configuring Port 9100
1.
In CentreWare IS, click
Properties
>
Connectivity
>
Protocols
>
Port 9100
.
2.
Next to
TCP-MSS Mode
, select
Enabled
if necessary.
Note:
TCP-MSS settings are common for LPD and Port 9100.
3.
If TCP-MSS mode is enabled, under
IPv4
, type the IP addresses for
Subnet 1
,
2
, and
3
.
4.
Ensure that the
TCP Port Number
is set to 9100.
5.
Set the
End of Job Timeout
to the desired number of seconds between 0 and 1800 before
processing a job with an
End of Job
character. The default time is 300 seconds.
6.
Click
Apply
.
Summary of Contents for WorkCentre 5320
