Copying
WorkCentre 5300 Series Multifunction Printer
User Guide
103
Output Format Adjustments
Use the Output Format tab to make the following changes:
•
Creating Booklets
on page 97
•
Including Covers
on page 104
•
Page Layout
on page 104
•
Creating Posters
on page 105
•
Adding Annotations
on page 105
•
Adding Watermarks
on page 106
•
Identification Card Copying
on page 107
Creating Booklets
Copies can be printed in the form of a booklet. The page images are reduced to print two images per
side of each printed page. The pages can then be folded and stapled manually, or with the appropriate
finisher, they can be creased and stapled automatically.
Note:
In this mode, the printer does not print the copies until it has scanned all the originals.
To create a booklet:
1.
Touch
Copy
on the touch screen, then touch the
Output Format
tab.
2.
Touch
Booklet Creation
, then touch
Booklet Options On
.
3.
Under
Original Input
, touch
1-Sided Originals
,
2-Sided Originals
or
2-Sided Rotated Originals
.
4.
If the Office Finisher LX with Booklet Maker option is installed, touch
No Crease & Staple
,
Crease
& Staple
or
Crease Only
.
5.
You can add margins in the center binding area to compensate for the thickness of the booklet:
a.
Touch
Binding Shift
, then touch the plus or minus (
+
/
–
) buttons to set the shift.
b.
Touch
Save
.
6.
To add covers, touch
Covers
, then touch
Blank Cover
,
Print on Both
or
1-Sided Covers
Print Outside
.
•
Touch the tray loaded with cover paper and the tray loaded with main body paper.
Touch
Save
.
•
To print the copy of the last original page on the back cover for
Blank Cover
and
Print on
Both
, touch
Last Page on Back Cover
, then touch
Save
.
7.
To sub-divide a large booklet into subsets, touch
Divide Output
, then touch
On
.
8.
To enter the number of sheets for each subset, touch the plus or minus (
+
/
–
) buttons, then
touch
Save
.
9.
Offset Stacking places each stack of printed pages slightly to the left or right of the previous stack
for easier separation.
a.
Touch
Output /Offset
.
b.
Touch
Center Tray Upper
or
Center Tray Lower
. For automatic creasing, touch
Right
Middle Tray
.
c.
Touch
Offset Stacking
, then touch
System Default
,
No Offset
,
Offset Per Se
t or
Offset Per
Job
, then touch
Save
.
10. Touch
Save
.
Summary of Contents for WorkCentre 5325
