Xerox WorkCentre 5687 Series Service Manual Download

Page: 1680 / 2320

August 2007

4-660

WorkCentre 5687 Family

ADJ 11.5-170

Repairs/Adjustments

ADJ 11.5-170 Booklet Tamping

Parts List on PL 11.81

Purpose

To set the tamper travel to give neat booklets without edge damage.

Procedure

Go to the appropriate check and adjustment from the following options:

•

If only A4 paper is available, go to A4 Paper Procedure.

•

If only 8.5 X 11 inch paper is available, go to 8.5 X 11 Inch Procedure.

A4 Paper Procedure

Check

Open the HCSS BM front door and insert an interlock cheater into the front door interlock
switch.

Fully pull out the BM module and release the jam clearance handle PL 11.80 Item 8, fully
open the paper guide PL 11.80 Item 7.

Do the following:

Enter dC131.

Select Diagnostic Routines.

Select Copier Routines.

Select dC131 NVM Read/Write.

Select 12Finisher/DFA.

Select 12-006 BookMkrTampRdyOff-set.

Select Read/Write and reduce the original value by 8.

Select Save, select OK, select Close, select Exit.

Enter dC330 code 11-065 BM Backstop Motor, select Start, allow the backstop to raise to
the receive position (where it will pause), select Stop.

Enter dC330 code 11-066 BM tamper 1 motor. Select Start to energize the tamper motor,
allow the tampers to move into the tamped position (where they will pause), select Stop.

Insert a single sheet of A4 paper, short edge downward into the booklet maker compiling
area, so that it rests on the backstop and is located between the two tampers

Bias the sheet towards the rear of the machine until the sheet touches the rear tamper,
Figure 1.

Observe the position of the sheet between the tampers, Figure 1.

•

If the sheet cannot reach the backstop because the tampers are too close together,
the NVM value will need to be decreased to move the tampers further apart, perform
the adjustment.

•

If the front tamper is not within 0.5mm (0.02 inch) of the sheet edge without touching
the sheet, the NVM value will need to be increased to move the tampers closer
together, perform the adjustment.

•

If the tampers are in the correct position, within 0.5mm (0.02 inch) of the sheet edge
without touching the sheet, do the following:

Enter dC131.

Select Diagnostic Routines.

Select Copier Routines.

Select dC131 NVM Read/Write.

Select 12Finisher/DFA.

Select 12-006 BookMkrTampRdyOff-set.

Select Read/Write and increase the value by 8.

Select Save, select OK, select Close, select Exit.

Adjustment

Do the following:

Enter dC131.

Select Diagnostic Routines.

Select Copier Routines.

Select dC131 NVM Read/Write.

Select 12Finisher/DFA.

Select 12-006 BookMkrTampRdyOff-set.

Select Read/Write and enter the new value to correct the error found during the
check. Increasing the value lengthens the tamping stroke (tamps to a narrower
dimension between the tampers. Decreasing the value shortens the tamping stroke
(tamps to a wider dimension between the tampers). One step = 0.53mm.

Xerox WorkCentre 5687 Series, Service Manual

Search results

Summary of Contents for WorkCentre 5687 Series

Reviews:

Related manuals for WorkCentre 5687 Series

Brands by name

Popular brands