27
NOS Selection
TCP/IP Protocol Configuration
B1
To view or change the settings of the Device's TCP/IP Protocol Configuration, perform the following
steps:
To access the TCP/IP Protocol Settings at the Device
1. Press
the
Log In / Out button
on the Control Panel.
2. Press
the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular
Confirm button
on the touch screen.
4. Press
the
System Settings button
(the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press
the
System Settings button
.
6. Press
the
Network Settings button
.
7. Press
the
Protocol Settings button
.
8. When the Protocol Settings menu displays, note that with the exception of selection one (Ethernet
Speed), the five additional selections provide directions that are specific to TCP/IP address settings.
Choose your setting of interest by pressing the numbered, horizontal selection line on the touch
screen. Note that the current status of each setting is shown on the applicable line. After pressing a
selection line, to access available settings press the
Change Settings
button in the lower right corner
of the touch screen.
Summary of Contents for WorkCentre 7228
Page 1: ...System Administrator s Guide WorkCentre 7228 7235 7245...
Page 300: ...701P46436...
