Xerox Mobile Scanner
User’s Guide
16
•
Scan functions
—The icon represents the color mode and file format for the scanned image.
•
Battery LED
—This light indicates the scanner’s power status.
USB cable port
—Connect the provided USB cable to charge the scanner. When connected to a computer, you can
transfer images from the USB flash drive or memory card.
USB flash drive port
—Insert a USB flash drive into this port to scan directly to the flash drive.
Memory card slot
—Insert an SD memory card into this slot to scan directly to a memory card.
Battery compartment
—Holds the rechargeable battery that powers the scanner.
Glass release button
—Separates the glass and rollers inside the scanner so that you can clean the scanner using
the cleaning swab.
3 blinks
Scanner not linked
—the scanner does not detect a storage device. Make sure a USB flash
drive or memory card is fully inserted into the back of the scanner. Power cycle the scanner if
needed.
4 blinks
Calibration error
—the scanner needs to be calibrated or the scanner failed to calibrate
successfully during a calibration routine. Re-start the calibration routine by press, hold-down
for 2 seconds, then release the function button. Please see
Calibrating Your Scanner
on
page 54.
5 blinks
Timeout
—the scanner timeout has started.
Continuous
Scanner busy
—either the scanner is scanning, saving files to the attached device, or it is
being calibrated.
Scans in color at 300dpi and creates a JPG (*.jpg) file.
Scans in black & white at 300dpi and creates an Adobe PDF (*.pdf) file.
Scans in color at 300dpi and creates an Adobe PDF (*.pdf) file.
Off
The scanner is not plugged in, the battery is not in the scanner, or the scanner is turned off.
On
The scanner power is on.
Blink
The battery power is getting low and needs to be recharged.
LED pattern
Scanner status
