M a n u a l I n s t a l l a t i o n P r o c e d u r e
C h a p t e r 5 : U s i n g t h e P r i n t e r w i t h U N I X T C P / I P
❖
5-23
Next you will need to configure the print queue, using one of the
following three options:
Print Queue Option 1: Setting up lpd
(page 5-27)
Print Queue Option 2: Setting up RPRINT on BSD Hosts
(page 5-30)
Print Queue Option 3: Setting up RPRINT on System V
Hosts
(page 5-32).
On some systems, such as AT&T System V, the ARP command
is implemented as arpbypass with the following syntax:
a r p b y p a s s - f 1 s e t
d d d . d d d . d d d . d d d
0 x n n . 0 x n n . 0 x n n . 0 x n n . 0 x n n . 0 x n n . 0 x n n
where the nns are hexadecimal digits.
For example:
a r p b y p a s s - f 1 s e t 1 2 6 . 1 6 . 1 . 2
0 x 0 . 0 x 0 . 0 x c 9 . 0 x 0 . 0 x 8 . 0 x 2 a
3
From the UNIX command prompt, enter:
p i n g
d d d . d d d . d d d . d d d
where
d d d . d d d . d d d . d d d
is the newly assigned IP
address.
You should see response packets from the XNIC displayed on
your screen. Your XNIC now has the new IP address in its
memory.
If there is no response, even after a few minutes, type the
command interrupt key (usually
< C t r l > < C >
) to stop the
p i n g
command and check your network setup.
Etr-ch05 Page 23 Thursday, October 24, 1996 7:31 PM
