M a n u a l I n s t a l l a t i o n P r o c e d u r e
C h a p t e r 5 : U s i n g t h e P r i n t e r w i t h U N I X T C P / I P
❖
5-27
Next you will need to configure the print queue, using one of the
following three options:
Print Queue Option 1: Setting up lpd
(page 5-27)
Print Queue Option 2: Setting up RPRINT on BSD Hosts
(page 5-30)
Print Queue Option 3: Setting up RPRINT on System V
Hosts
(page 5-32)
.
Print Queue
Option 1:
Setting up
lpd
Follow this procedure to use the native
lpd
print protocol on a
BSD host with the XNIC. Exact syntax may vary from one UNIX
system to another. First, determine if
lpd
is supported on your
system by entering:
p s - a x | g r e p l p d
Note
The
lpd
service is only defined for port 1 on the XNIC. This
port is the interface between the XNIC and the printer
controller board.
If the system does not return a process number for
lpd
, you
must use
rprint
as described in the section Print Queue
Option 2: Setting up RPRINT on BSD Hosts (page 5-30)
Etr-ch05 Page 27 Thursday, October 24, 1996 7:31 PM
