I m p o r t a n t I n f o r m a t i o n
1-12
❖
X N I C - E N E T / T R I N G C o n f i g u r a t i o n G u i d e
Default
Configuration
The XNIC is preconfigured with all protocols enabled using
the default settings. The default configuration is applicable
for most systems. It may be modified from a host that remotely
logs in to the XNIC through a virtual port.
In Novell, run the NetWare (TES) utility that is on the
Utilities for: LAN Server, LAN Manager, Novell NetWare
(TES) diskette provided with the XNIC.
In TCP/IP, run Telnet that is available generically in the
host operating system.
In DEC LAT use NCP that is available generically in the
host operating system.
Refer to each chapter in this guide for details on using these
utilities to modify the default settings.
Now you are ready to move on to Chapter 2,
Connecting the
XNIC
.
Note
If the configuration sheets do not print, verify that the XNIC is
properly installed, and that the printer control panel displays
the Online Ready message.
If DS/P is enabled on the XNIC, the Network Interface
Configuration sheets will not print. Make sure you print the
configuration sheets before enabling DS/P. The default DS/P
setting on the XNIC is disabled.
ETR-CH01 Page 12 Wednesday, October 23, 1996 6:41 PM
