U s i n g t h e P r i n t e r w i t h L A T o n X N I C - E N E T O n l y
C h a p t e r 6 : U s i n g t h e P r i n t e r w i t h L A T o n X N I C - E N E T O n l y
❖
6-3
Configuring
an OpenVMS
LAT Host for
LATSYM
The following is a procedure that the system administrator
may use to set up the printer queue on the host. The actual
commands will vary according to system configuration, type
of printer, and application requirements.
1
At the
$
prompt enter the following command:
r u n s y s $ s y s t e m : l a t c p
2
To set up a VMS application port, at the
LATCP>
prompt
enter the following sequence of commands:
c r e a t e p o r t
l t a n n n : / l o g
s e t p o r t
l t a n n n : / a p p l i c a t i o n -
/ n o d e = X N E
x x x x x x / s e r v i c e = X N E x x x x x x _ 1
e x i t
where
l t a n n n
is the port name assigned by the network
administrator.
The qualifier
node
represents the XNIC-ENETs server
name and the qualifier
service
represents the LAT
service name. Both can be found in the Ethernet portion
of the Printer Configuration Sheet. The service name is
the one identified under DEC LAT. The server name is
the service name without the _1 at the end.
For example: If the Service name is XNE1076E3_1, the
Server name is XNE1076E3.
If the name was changed, the new name must be used
instead. Be sure you match the case (upper/lower) of
the node name and port name. (To preserve case, use
quotation marks.)
ETR-CH06 Page 3 Wednesday, October 23, 1996 9:24 PM
