B a s i c X N I C - E N E T C o m m a n d s
C h a p t e r 6 : U s i n g t h e P r i n t e r w i t h L A T o n X N I C - E N E T O n l y
❖
6-7
Basic
XNIC-ENET
Commands
The basic XNIC-ENET commands are as follows:
SHOW
displays the XNIC-ENETs current information.
Display screens vary according to the specific SHOW
parameter. The syntax is:
s h o w
parameter
MONITOR
is the same as SHOW, except that the display
screen is updated every 10 seconds (every 1 second in
privileged mode). Press any key to exit the display. The
syntax is:
m o n i t o r
parameter
LIST
displays the XNIC-ENETs NVRAM (non-volatile
RAM) parameter settings. Display screens vary according
to the specific LIST parameter. The syntax is:
l i s t
parameter
SET
temporarily changes a parameter to a given value.
The change is valid until you log out from the
XNIC-ENET or turn OFF the printer. The syntax is:
s e t
parameter value
DEFINE
permanently changes an NVRAM parameter to
a given value. You must reinitialize the XNIC-ENET for
the changes to take place:
Use the Reset All or Reset Ethernet command on the
printer control panel (DocuPrint 4517 printer only).
Power off the printer and then turn it back on.
Issue an
init delay 0
command remotely.
The syntax is:
d e f i n e
parameter value
CHANGE
is a combination of
SET
and
DEFINE
; it
immediately changes a parameter and permanently
updates it in the NVRAM as well. The syntax is:
c h a n g e
parameter value
ETR-CH06 Page 7 Wednesday, October 23, 1996 9:24 PM
