B a s i c X N I C - E N E T C o m m a n d s
C h a p t e r 6 : U s i n g t h e P r i n t e r w i t h L A T o n X N I C - E N E T O n l y
❖
6-9
Table 6.1 lists the most useful XNIC-ENET commands,
organized by network environment and task.
Table 6.1 XNIC-ENET tasks and commands
Task
Command
Display information about the XNIC-ENET
characteristics and the specific options
that are enabled.
show server characteristics
Each parameter displayed may be altered using the appropriate
SET/CHANGE/DEFINE command.
If you have a VT100-compatible terminal, the show server
characteristics command displays a stack of overlapping
screens which can be cycled for display with the arrow keys.
Display revision levels and the self-test
results.
show server hardware
Display Document Services for Printing
(DS/P) parameters (refer to the
Document
Services for Printing Guide
)
.
show server dsp
Display the overall server configuration
and start-up parameter setting.
show server local
This command is disabled on the XNIC-ENET if DS/P is enabled.
Print a Network Configuration Sheet for
Ethernet.
show config port 1
This command is disabled on the XNIC if DS/P is enabled.
Display the overall network configuration,
including the Ethernet hardware address
and the protocols currently supported.
show server network
Change the login password from the
default of access at the prompt
showing #.
define server login password
password_1
(where
password_1
is the new login password)
Change the privileged password from the
default of system at the prompt
showing password>.
define server privilege password
password_2
(where
password_2
is the new privileged password).
Disable protocols on the XNIC-ENET.
define server authorize
protocol
disabled
(where
protoco
l is one of the following: NetWare, AppleTalk,
TCP/IP, LAT, NetBIOS, All, or None.)
Enable protocols on the XNIC-ENET.
define server authorize
protocol
enabled
(where
protoco
l is one of the following: NetWare, AppleTalk,
TCP/IP, LAT, NetBIOS, All, or None.)
ETR-CH06 Page 9 Wednesday, October 23, 1996 9:24 PM
