U s i n g t h e P r i n t e r w i t h L A N S e r v e r
8-22
❖
X N I C - E N E T / T R I N G C o n f i g u r a t i o n G u i d e
Setting
Optional
Configurations
(TCP/IP Only)
This section describes optional procedures for communicating
with the XNIC via TCP/IP to monitor system parameters or to
change the parameters from their factory defaults using
Telnet.
Logging into the
XNIC
To monitor or change configuration parameters on the XNIC,
you must first log into the XNIC from your host.
Use the following procedure to log into the XNIC from your
workstation:
Note
The permanently-set IP address on your printer must be set at
a value other than none for you to be able to perform these
instructions. To assign an IP address to your printer, refer to
Establishing an IP/Network Connection (TCP/IP Only)
(page 8-5).
To use Telnet, the workstation or the host must be on the same
network segment as the printer.
1
At the command prompt, enter:
T e l n e t
h o s t _ n a m e - p 2 0 4 8
2
At the
#
prompt, enter the password.
The default is
a c c e s s
. You will not see what you enter.
3
At the
Local>
prompt, enter:
s u
ETR-CH08 Page 22 Wednesday, October 23, 1996 9:46 PM
