B a s i c X N I C C o m m a n d s
C h a p t e r 8 : U s i n g t h e P r i n t e r w i t h L A N S e r v e r
❖
8-27
Reset the XNIC remotely (soft reset).
init delay 0
Reset the XNIC to factory defaults.
init delay 0 default
Display NetBIOS characteristics.
show server netbios
Display network configuration parameters.
show server TCP
Create a new remote printer service.
change service
name
tcp_port
priority
nn
(where
name
is the new service name,
tcp_port
is a value
between 3000 and 5000, and
nn
is a value of 0 to 15, with 15
being the highest)
Default services all have a priority of 0 (lowest priority). All files
sent to a new service set with a higher priority take priority over
files sent to the default services.
Quotation marks around the service name are required when
using upper and lower case characters in the name.
Define the printers IP address.
define server ip
ddd.ddd.ddd.ddd
(where
ddd.ddd.ddd.ddd
is the IP address of the printer)
Redefine the subnet mask.
define server subnet
mmm.mmm.mmm.mmm
(where
mmm.mmm.mmm.mmm
is the subnet mask for the
network)
Define gateway address.
define node ip
ggg.ggg.ggg.ggg
gateway default
(where
ggg.ggg.ggg.ggg
is the address of the default router for
the printers network segment)
Table 8.2 XNIC tasks and commands
(continued)
Task
Command
ETR-CH08 Page 27 Wednesday, October 23, 1996 9:46 PM
