I n i t i a l T e s t i n g
2-8
❖
X N I C - E N E T T / T R I N G C o n f i g u r a t i o n G u i d e
Initial Testing
After installing the XNIC and connecting the network cable,
you are ready to power on the printer and test the system as
follows:
1
Verify that the network cable is connected to only one port:
For Ethernet: BNC or UTP
For Token Ring: UTP or STP.
2
Power ON the printer.
Wait for the printer to complete its self-tests and display
Online Ready
.
3
Move to Step 4 if you are installing an XNIC-TRING.
Follow this step if you are installing an XNIC-ENET:
If the XNIC-ENET powers on properly and is connected to
the network via UTP (10baseT), the green LED (LINK) on the
XNIC-ENETs connection panel will be lit (for BNC
connection the green LED will be off).
The yellow LAN LED (RCU) will flash in accordance with
any network activity. If the yellow LED is not flashing and
you know there is network activity, verify that the
XNIC-ENET is properly connected to the network and the
printer is powered on.
Now continue with Step 5.
4
If the XNIC-TRING powers on properly and is connected to
the network, the LED on the Token Ring MAU will be lit.
5
Print a copy of the Printer Configuration Sheet. Then check
to see that the card is listed on the Configuration Sheet.
Refer to your printers user guide for instructions on printing a
configuration sheet, if necessary.
6
Configure your XNIC as described in the following chapters.
(The table on
Next Steps
(page 2-10) will help you
determine what chapters you need to read.)
Etr-ch02 Page 8 Thursday, October 24, 1996 4:49 PM
