U s i n g t h e P r i n t e r w i t h N o v e l l N e t W a r e
3-14
❖
X N I C - E N E T / T R I N G C o n f i g u r a t i o n G u i d e
Defining the Print
Job Configuration
(Optional)
The last task is to define a print job for special configuration
for the printer. There are many utility and add-on programs
that do this. Refer to your documentation for those programs
for further information.
If you also wish to configure the XNIC for Remote Printer
mode, go to the section
Configuring the XNIC as a Remote
Printer (NetWare 2.x/3.x)
(page 3-29).
9
Repeat steps 1 to 8 again on every File Server in the cross
link pool.
The Available File Servers (Available NetWare Servers
in 4.x) list should be the same on all File Servers that
will have the same common Print Server.
For example if File Servers A, B, and C on the network
need to be cross linked, perform steps 1 to
8 on Server A.
Then log in File Server B, and repeat steps 1 to 8.
Next log in File Server C and again repeat steps 1 to 8.
10
Power the printer off and power it on to restart the XNIC.
Refer to
Restarting the XNIC
(page 3-12) for detailed
instructions.
ETR-CH03 Page 14 Wednesday, October 23, 1996 6:46 PM
