U s i n g N W A d m i n
3-26
❖
X N I C - E N E T / T R I N G C o n f i g u r a t i o n G u i d e
Restarting the
XNIC
After you complete the setup in NWAdmin, the XNIC needs
to be restarted so it can read the new configuration in the
NDS file server. Power the printer off and then power it on to
restart the XNIC.
The following procedure is an alternative method to restart
the XNIC.
Note
If your network has more than 25 file servers, it is
recommended to configure the XNIC as follows before
continuing on to the next section Restarting the XNIC:
7. Setting NDS Context, (page 3-47)
8. Setting the NDS Tree, (page 3-48)
9. Disabling 3.x/BEM or NDS Discovery, (page 3-49).
Setting the above parameters on the XNIC will automatically
reset the XNIC. Therefore you can skip the next section
Restarting the XNIC and proceed on.
1
Exit NWAdmin and return to the DOS prompt.
2
Access PConsole.
3
Select
Print Server Information
from the
Available
Options
menu.
4
Select your XNIC Print Server name.
ETR-CH03 Page 26 Wednesday, October 23, 1996 6:46 PM
