X N I C C o n f i g u r a t i o n O p t i o n s
3-46
❖
X N I C - E N E T / T R I N G C o n f i g u r a t i o n G u i d e
Issue these commands from TES to set a preferred file
server name (preferred is the recommended option) in the
XNIC.
>define server netware required disabled
>define node
server_name
nfserver
>init delay 0
Issue these commands from TES to set a required file
server name in the XNIC.
>define server netware required enabled
>define node
server_name
nfserver
>init delay 0
Issue these commands to verify the required or preferred file
server setting on the XNIC.
>show node
The show node command will display a list of values
including
name
.
Name
gives the name of the required
or preferred file server.
>show server netware
The show server netware command will display a list of
values including
NFServer
.
NFServer
indicates if the
file server has been set as required or preferred.
5. Disabling
PServer Mode
(Required for
Large Networks)
The default is: Both PServer and RPrinter/NPrinter modes
enabled.
If XNIC is running as an RPrinter/NPrinter only, you have the
choice of disabling PServer on the XNIC.
Issue this command from TES:
>define server netware pserver disabled
>init delay 0
ETR-CH03 Page 46 Wednesday, October 23, 1996 6:46 PM
