S e t t i n g O p t i o n a l C o n f i g u r a t i o n s
C h a p t e r 3 : U s i n g t h e P r i n t e r w i t h N o v e l l N e t W a r e
❖
3-51
This procedure installs the TES/Kermit software on your
Novell workstation and establishes a connection with the
XNIC.
1
Insert the
Utilities for: LAN Server, LAN Manager, Novell
NetWare (TES)
diskette into your floppy disk drive and enter
the following command to install the files from the floppy
diskette in drive A: to hard drive C on your system:
a : \ t e s \ i n s t a l l a : \ t e s c :
2
Run TES by entering:
c d c : \ t e s - k r m t
t e s
To display information about TES commands, at the
DOS prompt, enter:
t e s h e l p
3
Run Kermit by entering:
k e r m i t
The
MS-Kermit>
prompt will appear.
You can optionally enter the following command to view a
listing of the XNIC cards on the network:
tes names
For example, you will see:
XNExxxxxx
for
XNIC-ENET o
r
XNT
xxxxxx
for XNIC-TRING, where
xxxxxx
is the last six
characters of the XNIC address
.
4
Specify which XNIC to use. Enter:
s e t p o r t t e s X N E
xxxxxx (
for
XNIC-ENET
)
or
s e t p o r t t e s X N T
xxxxxx (
for
XNIC-TRING
)
For example:
s e t p o r t t e s X N E 1 0 7 6 E 3
ETR-CH03 Page 51 Wednesday, October 23, 1996 6:46 PM
