B a s i c X N I C C o m m a n d s
C h a p t e r 3 : U s i n g t h e P r i n t e r w i t h N o v e l l N e t W a r e
❖
3-55
Table 3.2
XNIC Tasks and Commands
lists the most
useful XNIC commands, organized by task.
Table 3.2 XNIC Tasks and Commands
Task
Command
Display information about the XNIC
characteristics.
show server characteristics
Each parameter displayed may be altered using the appropriate
SET/CHANGE/DEFINE command.
If you have a VT100-compatible terminal, the show server
characteristics command displays a stack of overlapping
screens which can be cycled for display with the arrow keys.
Display Document Services for Printing
(DS/P) parameters. (Refer to the
Document
Services for Printing Guide.
)
show server dsp
Display the XNIC node parameters.
show node
Display the overall network configuration,
including the XNIC hardware address and
the protocols currently supported.
show server network
Print Network Interface Configuration for
Ethernet or Token Ring sheets
show config port 1
If DS/P is enabled this command is disabled on the XNIC.
Change the privileged password from the
default of system at the prompt
showing password>.
define server privilege password
password_2
(where
password_2
is the new privileged password)
This command changes the SU user password.
Disable protocols on the XNIC.
define server authorize
protocol
disabled
(where
protoco
l is one of the following: NetWare, AppleTalk,
TCP/IP, LAT, NetBIOS, All, or None.)
Enable protocols on the XNIC.
define server authorize
protocol
enabled
(where
protoco
l is one of the following: NetWare, AppleTalk,
TCP/IP, LAT, NetBIOS, All, or None.)
ETR-CH03 Page 55 Wednesday, October 23, 1996 6:46 PM
