In the box
- One YugenFace Wall or Stand
unit
- One 9V supply unit
- This guide booklet
Check that you have all of the inclu
-
ded parts listed on “In the box”. In
case of one or more parts missing,
contact the seller or the manufactu-
rer immediately.
Installing the device
1 - Locate the female connector on the cable on the device and the
equivalent male connector on the cable of the supply unit.
2 - Plug the supply male connector in the female one, taking care not
to damage the two parts.
3 - Place the device in its final location. If the unit is a “wall model”,
use wall plug or equivalent element (not included) to hang the unit on
the wall (or any vertical surface) possibly at a height of about 150cm.
Please pay attention that the fixation on the wall is strong enough
to sustain the weight of the device.
If the unit is a “stand model” just
place the unit in its designated location.
Please pay attention as the
“stand” unit weight exceeds 10kg.
4 - Plug the supply unit to an electricity outlet.
5 - After few seconds the device is ready to use
Enabling auto-update
In order to function optimally, the device needs internet connectivity to
be continuously updated. As this represents an essential element of
the product, the manufacturer cannot guarantee optimal functionality
otherwise.
Please, follows these steps:
1 - Make sure to have installed the device following the steps in the
previous section
EN
Summary of Contents for XFCEU-220W
