XETEC F.A.C.T. F-3 Manual Download

Page: 2 / 6

Thank you for buying this

product and thank you for your confidence!

With this

product you have purchased an innovative and professional

High-End product, which will enable you to enjoy your music on a very high
quality level for many years.

We have especially focused on electronic as well as product design to give
you a product that will accompany you for many years, as our products are
always one step ahead and will still be modern for many years.

products represent the experience our engineers have made through

many years assisted by car audio magazines as well as professional installers.

Please read these instructions very carefully, to avoid unnecessary trouble
and defects. In case of trouble, please contact your local dealer or check our
website

for troubleshooting.There we also offer up-to-date

hints and technical support for you.

is a State-of-the-Art 2- or 3-way active crossover

designed to be used together with high-quality speaker systems, and
especially matches the
means Full Active Crossover Technology and offers great improvement
even to any existing speaker set.

additionally comes with the option of using

modules, that are matched to the acoustic requirements of specific

car models.

provides everything you need to set up a 3-way active

loudspeaker system.

The x-over frequency between tweeter and woofer is adjustable with one
control.

It can be varied from 2.3 kHz to 6.5 kHz with 12 dB Linkwitz-Riley
characteristics.

Center position is 4.1 kHz, the usual x-over frequency of 2-way compo
speakers.

XETEC

www.xetec.de

XETEC F.A.C.T.fi F-3

XETEC Modular Speaker System. F.A.C.T.fi

XETEC F.A.C.T.fi F-3

XETEC

carEQfi

XETEC F.A.C.T.fi F-3

TWEETER AND WOOFER:

Additionally the phase shift of the tweeter channel can be adjusted and
b/- 180 degrees for each channel separately.

XETEC 3-KANAL FULL ACTIVE

CROSSOVER TECHNOLOGY F.A.C.T. F-3

With the feature woofer highpass it is possible to adjust the lower woofer
x-over frequency between 45 Hz to 250 Hz. Middle position is 115 Hz.

The option bass highpass defines the lower x-over frequency, that means
the frequency the bass range starts. (22 Hz-160 Hz) center position is 90 Hz.

The option bass lowpass defines the upper frequency, that means the
frequency the bass range ends. Middle position is 90 Hz. All filter
characteristics are 12 dB per octave.

The switch mode front / rear is exclusively for the use of carEQfi module,
and provides selection whether the F-3 is used for a front or rear system,
because the carEQfi modules are always for 4- channel use.

With the features system level , tweeter level and bass level the gain
of each channel can be adjusted in order to match the different efficiencies of
the drivers.

All features of

active crossover show the conceptional

advantages of active loudspeaker management :

- All power amps connected to

only get the user

defined frequency range, and must not reproduce the whole frequency
range that would be filtered in a passive crossover. This relieves the
power amps and increases the systems efficiency.

- With the

you get an open, modular full active

crossover concept, which improves any loudspeaker solution.
If you operate

with a

carEQfi module, you

get an outstanding performance perfectly adapted to your vehicle·s
acoustical environment.

- The tweeter phase shift range can be adjusted variably and separately

for each channel. This option would be impossible in passive crossover
solutions.

BASS CHANNEL: MIDBASS OR SUBWOOFER

XETEC F.A.C.T.fi F-3

XETEC

SAFETY

Before you make any connection, the battery must be
disconnected!
A main fuse must be installed into the +12 V wire within
+ the first 12" from the + terminal of the battery
(insurance regulation!).
The fuse in the power line only protects the device itself,
not the battery and the car!