K021 Instructions v1.0
Bag I
Page 62
BAG
I
FINISH IT UP
INSTALL THE SERVO
I1)
Consult the Set-Up sheet and Tuning Section to determine if your servo will be in
the forward or rear position. Remove the servo mount bag ASC 7336) from Bag
I. It includes two servo mounts and the necessary bolts. There are also some
spacers allowing fine adjustment of your servo position, though most Team
drivers only use them to space the servo forward if it hits the chassis when trying
to use the rear mounting holes.
I2)
Install the servo mounts to your servo (servo not included) using the button head
screws and washers included in the servo mount bag. We’ve found this easiest
to do by threading the button head screws into the mounts slightly, sliding the
mounts on to the servo tabs, and then finger tighten the screws. The mounts go
under the mounting tabs; looking at the top of the servo, the mounts should face
down while the output shaft is on the left.
