48
CN1100 Access Point - Installation Guide - G7601 - 3.8
1.
Install the CN1100s and antennas.
2.
Power on the CN1100, and then open the
CN1100 Management
window, as described in the
topic
Configuring the CN1100 Access Point
on page
16
.
3.
On the
CN1100 Management
toolbar, click
Settings
, and then click the
xMax
tab.
4.
Click
Auto
to enable all channels, or click any individual channels to be scanned. These channels
will be green.
Disabled
channels will be white.
NOTES
When selecting channels, consider the potential of channel interference, especially when the
network has multiple towers or when in close proximity to outside networks.
For additional information please refer to the topic
Channel Selection Tips
on Page 49.
Be sure to record the channel numbers selected for each CN1100.
When
Auto
mode is not selected, at least as many unique channels as devices within the
same network must be selected. Failure to do so may cause one or more devices to fail to
connect.
5.
Click
Save & Apply
.
Wait for the CN1100 to reboot and the refresh the screen.
6.
Repeat steps 2 through 5 for each CN1100.
IMPORTANT
Be sure to wait at least two minutes before powering up each successive CN1100.
