29
CN3200 Access Point - Installation Guide - G7604 - Release 3.3
B
A
C
D
D
C
B
A
These steps outline the basic tasks required to prepare for a successful installation of the CN3200
Dual Band Routing Modem using the two provided panel antennas. These initial steps prepare the
CN3200 for placement in a service location.
1.
Locate the supplied mounting bracket and secure the CN3200 Modem to the bracket with
four (4) hex-head screws, as shown.
Mounting Bracket
2.
Align the bracket onto the threaded posts on the back of the xMax Panel Antenna
and then secure it with 4 hex-nuts, as shown.
3.
Using the photos below, and the wiring diagram in the topic
Antenna Configuration
on page 18,
as a guide, secure the four supplied cables to the antenna connectors and the CN3200 Modem
connectors.
IMPORTANT
Ensure that the correct Modem connector is attached to the correct antenna connector.
