6
xMax 2.4 GHz Access Point - Quick Start Guide - G7605 - Release 2.0
These notices apply to the CN1300 xMax 2.4 GHz Access Point.
Be sure to read, understand and follow these instructions.
Heed all warnings.
Only use accessories and attachments specified by xG Technology.
Keep a copy of these instructions for future reference.
The CN1300 xMax 2.4 GHz Access Point
MUST
only be installed by a professional installer. It is the
responsibility of the installer to adjust the transmit power level to ensure that the output power plus
antenna gain does not cause the device to exceed FCC Part 15 output power regulations.
Hazardous situation, which if not avoided,
could result in death or serious injury.
All antennas
MUST
either be located on the exterior of a vehicle or mounted on a pole.
Every antenna
MUST
be separated from users by more than 23 cm (0.75 ft) at all times.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio technician for help.
Summary of Contents for xMax CN1300
Page 1: ...G7605 Release 2 0...
