PROGRAMMING THE X-ARCADE
(ADVANCED USERS)
The X-Arcade™s has 4 memory banks. Mode 1 is factory programmed and non-changeable. Modes 2-4
are fully programmable as many times as you want.
NOTE:
If you want to switch
MODES
after programming, you slide to
that MODE, then
PRESS LOAD BUTTON 2 (TWO) TIMES
. Don't forget this step.
Remember to
HOLD THE BUTTON ON
the X-Arcade and
KEYBOARD
together until LED FLASHES
11
10
Memory selection is achieved with the switch behind the X-ARCADE™
Programming:
First, remember that
MODE 1
cannot be programmed.
Start By Choosing Mode 2, 3 or 4 by sliding the switch toward the single button on back.
1. Press the black button
(LOAD BUTTON)
on the back of X-Arcade™ (
the red LED turns off
).
2. Select and hold any button (or direction on a joystick: UP, DOWN, LEFT or RIGHT) on the
X-Arcade™ (keep holding during Step 3!)
3. While holding button in Step 2, Select and hold a key on the keyboard until the LED light
to the right starts to blink. Once the light starts blinking, the button on the X-Arcade™ has
been programmed to the keyboard button selected in step 2.
4. Repeat steps 2 & 3 to program additional buttons. (Do not press load again)
5. Press the
LOAD BUTTON
to close out and save your entire programmed mode!
All the programmed buttons will be saved permanently in the X-Arcade’s on board memory. If you turn
off the computer, or unplug the X-Arcade™, the programmed buttons will not be lost. The X-Arcade™
can be reprogrammed as many times as you like. This hardware based function was designed to
allow easy use with any Operating System. So, read it over a few times. Otherwise, you can also
just assign keys in each individual game.
NOTE:
When switching between modes, you activate the
MODE
by
sliding the toggle switch to the
MODE
, then pressing the
LOAD
button
on the back of X-Arcade twice.) Remember, anytime you wish to
change
MODE
, after you slide the switch,
PRESS LOAD BUTTON TWICE!
C
5
X
PLAYER 1
START
START
PLAYER 2
3
4
X-Arcade
Button Configuration
Z
6
Q
A
S
W
E
CLOSE
BRACE
CLOSE
BRACE
L-Ctrl
L Alt
Space
OPEN
BRACE
