07
Dolphin Generation 2 Maintenance Manual V1.0
DOLPHIN XP-005L
2.11 Replace the key switch and USB port
Replace
the key switch
needs to refer the
P1 and P2
and remove the
screws in the
black frame
, and remove the rear cover, then refer to the
picture on the right, remove the screws securing the switch on the rear cover
in the green frame, then replace it.
Replace
the fuse
need to refer to the picture on the right, on the back of the
machine, remove the screws in the
red frame
, and rotate it out to replace it.
2.12 Replace clamp parts
M2 clamp
: Rotate the knob outward on the left picture, then it can be disassembled. Replace the
corresponding parts according to the picture on the right.
Note:
M2 clamp needs to pay
attention to
the gaps
in the
fright figure , align it before
tightening, Otherwise, it may
get stuck.
M5 clamp
:Remove the nut in the
white frame
and remove the screws in the
red frame
on the picture
below, rotate the knob outward on the left picture, then it can be disassembled. Replace the
corresponding parts according to the picture on the right.