03
Sleep Mode
Place the earphones back into the charging case and close the lid, the
earphones will disconnect and go into sleep mode automatically.
Wearing
Take the earphones out of the charging case, and insert them into
your ears according to the left (L) and right (R) marks.
Note: After using the earphones, place them back into the charging
case. This will extend their lifespan and help you avoid losing or
misplacing them.
Connecting
Connecting the earphones to a new device
①
Place the earphones into the charging case, then press and hold
the function button for 2 seconds. The charging case indicator
light will start blinking, indicating that the earphones are waiting
to be connected.
②
Enable the device's Bluetooth, then locate and connect to "Mi TW
Earphones 2S". If a passcode is requested, enter "0000".
●
Connecting the earphones with a Mi phone
Place the earphones into the charging case and close its lid. Make
sure the Bluetooth function is enabled on your Mi phone. Hold your
phone close to the charging case, then open the case's lid. Follow the
on-screen instructions of the phone to connect to the earphones.
Note: The feature of fast connection is currently only supported by
some Mi phones, please update your Mi phone to the latest stable
version.
●
Connection interrupted
When a device's Bluetooth is disabled, or if the earphones are out of
range, the earphones will automatically enter awaiting connection
mode. If the earphones remain disconnected to a device for 5
minutes, they will enter sleep mode. Wearing the earphones again will
wake them up and enter awaiting connection mode.
●
Automatic connection
While the earphones are in the charging case, opening the case will
cause the earphones to automatically connect to the most recently
used Bluetooth device. If no connection history is detected, or if the
earphones cannot successfully connect to any Bluetooth device, the
earphones will automatically enter the awaiting connection mode.
Note: If the earphones cannot automatically connect to a device, you
will need to manually connect the earphones to the desired device via
the device's Bluetooth settings.
