Maintenance and Calibration
Propellers
Battery
Self-check
Compass calibration
Propellers are wearing parts. When they're damaged,
replace them in time to ensure flight safety and efficiency.
Code pairing
When replacing a new remote or aircraft, code pairing
between your remote and aircraft should be renewed as
follows:
Do not throw the battery into fire; Do not batter the battery;
Lithium battery's capacity reduces significantly in low
temperature conditions. Do not use the battery when it is
below 5 degrees.
1 Turn on the aircraft.
Gimbal Mount Switch
Code Pairing Hole
2 Turn on the remote. 15 seconds later, press and hold
the power button until you hear a beeping sound and
the power button flashes
3 Unlock and remove the gimbal cap to locate the code
pairing hole. Press the screwdriver into the hole for one
second and let go for the aircraft to enter code pairing
state, confirmed by that the white lights on the aircraft
are out.
4 The code pairing succeeds when the power button
flashes white light and the white lights on the aircraft
resume.
The drone self-checks every time after turned on. When
self-check fails, a notification will be sent in your App.
The compass needs recalibration when magnetic field
changes. Follow instructions in the App to recalibrate the
compass.
