8. Care and Storage
Note: A fully charged scooter runs about 120-180 days of standby time. The battery has a smart chip, that stores information about its charging-
discharging. If you are not charging the battery for a long time, it can cause serious damage, for which it is impossible to charge the device again. This
kind of damage is not included in free warranty service. (Caution: Do not disassemble the device by unauthorized people, as there is a risk of electric
shock or serious injury as a result of a short circuit).
Adjusting a brake disc
If a brake is very tight: using M5 hex wrench and scroll
counterclockwise screws of brake disc tensioner pulley,
slightly shorten a length of a tail brake cable, then tighten a
tensioner pulley. If you think that brake is very free, loosen a
tension pulley, pull a brake cable to slightly increase a length
of its tail. Tighten a tension pulley.
Adjusting a handle bars
Staggering of steering rack: using a M5 hex wrench, tighten
two screws near the folding mechanism.
Using a connecting pipe to pump wheels
If a rear wheel of Mijia Electric Scooter deflated, connect a
connecting pipe to a wheel nipple to pump it. First, remove the
a cap of pin, then tighten a fitting, and then you can start to
pump a wheel.
12
