07
EN
* When using the bedside lamp in a new network environment, you need to restore factory settings
and connect to the network again.
Restore Factory Settings
Simultaneously press and hold the power button and mode button for 5 seconds, until the lamp starts
circulating through the colors red, green and blue, then release the buttons. After the circulating
colors end, the lamp will automatically restart, and restoring factory settings will be completed.
Precautions
Make sure the voltage is consistent with the product's working voltage before use. Using the
incorrect voltage may damage the product and cause a potential safety hazard.
The light source of this lamp is irreplaceable. When the light source reaches the end of its service
life, the entire lamp needs to be replaced. Do not disassemble this product.
The lamp will produce heat during operation, please use it in a well-ventilated area so that heat
can dissipate.
Do not use non-standard adapters to avoid product damage or safety hazards.
Place the lamp steadily and do not tip it over during use.
Under normal use of condition, this equipment should be kept a separation distance of at least 20cm
between the antenna and the body of the user.
