MNC-0300-011
12 of 26
Revision H
Unpacking and Installation
Table 1, Digital Monitor and Control Connector J1 Pinouts
Pin
Signal
Description
A
Reserved
Reserved
B RS-232
RX
C RS-232
TX
D Reserved
Reserved
E RS-232
GND
F Reserved
Reserved
G Reserved
Reserved
H Reserved
Reserved
J Reserved
Reserved
K
System GND
System GND
L RS-422/485
Transmit
+
M RS-422/485
Transmit
-
N RS-422/485
Receive
+
P RS-422/485
Receive
-
R RS-422/485
GND
S
Summary Fault A -- Normally
Open Contact
S Closed to U when Fault
T
Summary Fault A -- Normally
Closed Contact
T Opened to U when Fault
U
Summary Fault A
Summary Fault A Common
V
Summary Fault B -- Normally
Open Contact
V Closed to X when Fault
W
Summary Fault B -- Normally
Closed Contact
W Opened to X when Fault
X
Summary Fault B
X Summary Fault B Common
Y
RF Inhibit Opto isolator Low
RF Inhibit -- Connect Pin Y to either Pin Z or Pin a,
and Pin g to Pin f to Inhibit RF
Z
System GND
System GND
a
System GND
System GND
b
+24 VDC Out
+24 VDC Current limit of 100 mA
c
+24 VDC Out
+24 VDC Current limit of 100 mA
d
A/B Amplifier
A/B Amplifier select
e Re-program
Computer
Re-program Computer command Low
f
+15 VDC Out
+15 VDC Monitor and Opto-isolator Bias Supply
g
RF Inhibit Opto isolator Hi
RF Inhibit -- Connect Pin g to Pin f, and Pin Y to either
Pin Z or Pin a to Inhibit RF
h
Reset Computer
Connect Pin h to either Pin Z or Pin a to reset
computer.
j
RF Output Analog
V
o
= 10
(PdBm - 47.27)/19.05
Summary of Contents for XTS-200C
