MNC-0300-011
25 of 26
Revision H
Unpacking and Installation
Local and Remote Operation
Xicom Technology ODUs have a built-in microprocessor for remote
Monitor & Control using Xicom Standard Protocol. To operate from a
remote position refer to the chapters titled
Operation
and
Amplifier
communication and Protocol
for detailed information.
There is one switch on the front panel of the amplifier that allows you
some local control of the unit. This switch is the Primary Power Switch
and is used to turn AC input power ON or OFF.
There is also a LED indicator on the amplifier front panel. Depending on
the state of the amplifier, this indicator shows:
•
AMBER when the unit is in standby.
•
GREEN when transmit is enable and there is no fault.
•
RED when a fault occurs during standby.
•
Flashing GREEN/AMBER when th unit is in transmit and RF is
inhibited.
•
Flashing GREEN/RED when a fault occurs during transmit.
Operating Procedure
Note
The power supply must be enabled and RF enabled for the
amplifier to operate properly.
Use this procedure to operate the amplifier in LOCAL.
1. Ensure that all Waveguides are connected.
2. Connect the amplifier to the primary power source.
3. Turn the Primary Power Switch ON.
Summary of Contents for XTS-200C
