2
See fig 2 and fig 5.
2.1.5 Turn the pin roll 2 to the original position, and push longitudinally to the end. Then
put spring pin 1 get across pin roll 2 to reset.
2.1.6 See fig 3, turn the hand grip to the level position, pull out pin 7 and save pin 7 with
care for next use.
Fig. 3 Fig. 5
2.1.7 Try to rock the hand grip and operate different positions of control handle knob 8 to
examine the lifting, free position and dropping and check that whether the different
positions are normal or not. See fig 4
2.1.8 The screw 9 in fig 5 is used to adjust the truck situation. When the truck body drops
immediately after it is lifted, you should
turn the screw 9 a little counter
-clockwise. And then try the truck again
until truck body could lift normally. If the
truck body couldn’t drop after it is lifted,
you should turn the screw 9 a little
clockwise. And then try to operate truck
again until the truck body could drop
normally. The external hexagon nut 10 at
screw 9 plays the locking function in the
truck. So you should undo the external
hexagon nut 10 before adjustment. And
screw down the nut 10 after you finish
the adjustment.
2.2 Instrument installation
2.2.1 Steelyard stand should be placed as
indicated in fig6 and align the fixed
holes. Fig. 6
2.2.2 Use three screws 11 to fix the steelyard stand as shown in fig 6.
Fig. 4
