xiQ - Technical Manual Version 1.0
54
3.13.
U3PE-FL1009
2-port USB 3.0 to PCI Express x1 Gen2 Host Card
figure 3-52, picture U3PE-FL1009
Technical Specifications
Controller
PCI Express to USB 3.0 Single Chip Host Controller Fresco FL1009
PCIe Host Bus
Single (x1) PCI Express Lane
Supports PCI Express Specification Revision 2.1 at 5GT/s
Supports PCI Bus Power Management Interface Specification revision 1.2
USB Features
Compliant with USB 3.0 Specification Revision 1.0
Compliant with Extensible Host Controller Interface (xHCI) Specification revision 1.0
2 downstream USB ports support SS/HS/FS/LS data rates (5Gbps/480Mbps/12Mbps/1.5Mbps)
Advanced Power
Saving
Support all USB 3.0 Power States: U0, U1, U2 and U3
Support USB 2.0 Link Power management (LPM)
USB-IF LPM PDK Standard
PCIe Active State Power Management (ASPM) L0s and L1
USB3 cable lock
mechanism
Provides the threaded holes for the jack-screws of USB 3.0 A Plug w/Jackscrew lock Cable
Distance between the hole midpoints: 19mm, threads: M2 x 0.4
table 3-38, technical specification, U3PE-FL1009
Computer Platform
•
Computer with PCI Express slot (x1, x4, x8, x16)
Note:
o
U3PE-FL1009 needs PCI Express 25W slot (x1, x4, x8, x16)
o
For the best performance (5.0 Gbps), U3PE-FL1009 should be installed in a PCIe Gen 2 compliant slot in the host
computer. Most computers have PCIe Gen 2 (5.0 Gbps) throughput on x8 or x16 slots.
A PCIe Gen 1 compliant slot reaches up to 2.5 Gbps throughput
Operating System Requirements
•
Windows XP, Windows Vista, Windows 7, Windows 8
USB 3.0 Host Drivers for x86 (32-bit) and x64 (64-bit) for Windows XP, Windows Vista, Windows 7