CA-1/PA-1
CA-1
FQA
7
Sound source turned off
Signal cable is broken
Speaker cable is broken
Signal selector switch wrong
Root noise of sound source too big
Signal shielding effect badly
Signal source input phase opposed
Speaker wire to channels has exchanged
or positive negative reversed
Turn on the sound source.
Check and change signal cable.
Check and change speaker cable.
Change a higher SNR sound.
Left and right
channel confused
Indicator always
glitters
There is problem on preamplifier,
Loudspeaker cable or loudspeaker
Check the preamplifier, loudspeaker
cable or loudspeakers
Problem
Problem
Possible Cause
Possible Cause
Trouble-shootings
Trouble-shootings
The machine is
not electrified
Power connector not plug well
Fuse has fused
Plug the power connector again.
Change the fuse coincide with the
prompt
requirement.
Speaker no
sound
Noise too big
Tune input selection button
according to
sound source.
Connect according to the indication
of left
and right channel.
Change eligible signal cable
In order to help user operate this amplifier more convenient, following is some frequently asked
questions during the operation. If you want more information, please access www.xindak.com , E-mail:
service@xindak.com or call: +86 028 84711993. Chengdu Xindak Electronic will service you with all our
heart.
How To Use
How To Use
