6
Operation Instruction
Chapter 3
XA8550
3.2 General Problems and Trouble-shootings
Problem
Possible cause
Trouble-shootings
t
he machine is
not electrified
Power connector not plug well
Fuse has fused
Plug the power connector again.
Change the fuse coincide with the prompt
requirement.
There is no
sound
Sound source turned off
Signal cable is broken
The volume is turned down to the minimum
Signal selector switch wrong
Root noise of sound source too big
Signal shielding effect badly
Signal source input phase opposed
Speaker wire to channels has exchanged or
positive negative reversed
Noise too big
Left and
right channel
confused
Turn on the sound source.
Check and change signal cable.
Turn up the volume.
Replace the sound source with another
one with higher Signal to Noise Ratio.
Tune input selection button according to
sound source
.
Connect according to the indication of left
and right channel.
Change eligible signal cable
Notice: if you have been confronted any problems when using this product or have any suggestion to tell us, please visit
the wesite of xindak: http://www.xindak.com, you may access our instant technique support here.
