OWNER’S/OPERATOR’S
MANUAL
16. MAINTENANCE
16- 16
STORAGE TIPS
CAUTION
Do not start the engine during the storage period. This will disturb the protective film
created by fogging.
Cleaning
——Clean the UTV thoroughly.
Oil Add and Filter Change
——Stop the engine and change oil and filter.
Air Filter/Air Box
——Inspect and clean or replace the pre-cleaner and air filter.
Clean the air box and the sediment tube.
Inspect All Fluid Levels
——Inspect the following fluid levels and change if
necessary: transmission; brake fluid (change every two years or as required if fluid
looks dark or contaminated).
Fog the Engine
——Spray a light oil into the cylinder through the spark plug hole.
Check and Lubricate Cables/Grease
——Inspect all cables and lubricate.
Battery Maintenance
——Remove the battery and add electrolyte as required to the
proper level. Do not use tap water which may contain minerals that reduce battery life.
Apply Dielectric Grease to the terminal bolts and terminals. Charge the battery.
Storage Area/Covers
——Set tire pressure and safely support the UTV with the tires
1-2”(25-50mm) off the ground. Be sure the storage area is well ventilated. Cover the
machine with a UTV cover.
NOTE:
Do not use plastic or coated materials. They do not allow enough ventilation
to prevent condensation, and may promote corrosion and oxidation.
TRANSPORTING
Whenever the UTV is to be transported the following measures should be taken.
1. Turn off the engine and remove the key.
2. Be certain the fuel cap, oil cap, and seat are installed correctly.
3. Always tie the frame of the UTV to the transporting with securely using suitable
straps or rope.
4. Always place the transmission in gear and lock the parking brake.
