- 4 -
Caution
1. Please install and use this product under the environmental conditions specified in the general specifications of
the manual.
Do not use in places with humidity, high temperature, dust, smoke, conductive dust, corrosive gas, combustible
gas, vibration and impact.
It may cause electric shock, fire, misoperation, product damage, etc.
2. Do not directly touch the conductive part of the product.
It may cause malfunction and failure.
3. Please use Xinje XG-EB series special guide rail to fix this product, and please install it on a flat surface.
Incorrect installation may cause malfunction and product damage.
4. When processing the screw hole, please do not let the cutting powder and wire debris fall into the product shell.
It may cause malfunction and failure.
5. When connecting the expansion module with the expansion cable, please make sure that the connection is tight
and the contact is good.
It may cause poor communication and malfunction.
6. When connecting peripheral devices, expansion devices, batteries and other devices, be sure to cut off power
for operation.
It may cause malfunction and failure.
⚫
Product wiring
Warning
1
．
Cut off external power before wiring. Otherwise, an electric shock may occur.
2
．
Connect AC or DC power to special power terminal correctly. Otherwise, may burn the controller.
3
．
Close the panel cover plate before controller powering on and running. Otherwise, an electric shock may occur.
Caution
1
．
Do not connect external 24V power to controllers’ or expansion modules’ 24V and 0V
terminals, products damage may occur.
2
．
Use 2mm
2
cable to ground the ground terminals of expansion modules and controllers, never common ground
to high voltage system. Otherwise, products fault or damage may occur.
3
．
Do not wiring between idle terminals. Otherwise, incorrect action or damage may occur.
4
．
Avoid ablation powder or clastic wires into product shell when processing screw holes. Otherwise, incorrect
action or fault may occur.
5
．
Tighten up wiring terminals and separate conductive parts. Otherwise, incorrect action or product damage may
occur.
