Operation
1. Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop, for continuous
Operation, pull the trigger and then push in
The lock button, to stop from the locked
Position, just press the trigger fully, then
Release it.
2. Operate this demolition hammer by utilizing extra pressure. The performance will be better if it is
pressed properly against the work surface.
Note:
Sometimes the power tool does not begin the striking the stroke even the motor keep running,
because oil inside become thick. If the power tool is used at a low temperature, or it is used after a
long idle time, this demolition hammer should be kept running for above 5 minutes to warm up.
How to replace grease
This demolition hammer is full of air-tight structure to protect against dust and to prevent lubrication
leakage.
Therefore, this hammer can be used without lubrication for a long period. Replace grease as
described below.
1. After purchase, replace the grease inside each time when carbon brush was changed.
Before do it, please unplug the plug!
2. Please open the grease cover as picture
Show, wipe off all old grease completely,
Then replace with new specified grease
30g,
Oil type is:Egols8466,quantity is 30g
.
too more or too little will cause the
machine non-properly work.
3. Make sure that lock the cover tightly,
And assembly the disassembled parts correctly
4. Clean the machine.
5. Maintenance
