Prior to operation
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which specified on the
name plate of the hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power receptacle
while the power switch is in ON position, the demolition hammer will start operation immediately, which
can cause serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and
rated capacity. The extension cord should be kept as short as practicable.
Assembly
Side Handle(with soft synthetic rubber padding)
Operate your power tool only with the Side Handle
8.
The Side Handle
8
can be set to any position(360
°
circumrotate) for a secure and low-fatigue working
posture.
Loosen the Function Knob
9
, rotate the Side Handle
8
around the axis of the power tool to the required
position and tighten the Function Knob
9
again.
Changing the tool
Before any work on the power tool itself, pull the mains plug.
With the SDS-max tool holder. Simpler and easier tool changing is possible without additional aids.
The Hammer rod protector
1
largely prevents the entry of drilling dust into the tool holder during operation.
When inserting the tool, take care that the Hammer rod protector 1 is not damaged.
A damaged Hammer rod protector
1
should be changed immediately. We recommend having this carried
out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end
of the tool.
Insert the tool in a twisting manner into
the tool holder until it latches itself.
Check the latching by pilling the tool.
Removing (see figure B)
Push back the Protective lining
2
and remove
the tool.
CAUTION:
The insert tool may become hot during
Use. There is a risk of burning the hands. Wear
Protective gloves when changing insert tools.
