Special Warning for Electric hammer
•
Wear ear protection. Exposure to noise can cause hearing loss.
•
Use auxiliary handle with the tool. Loss of control can cause personal injury.
• Hold Power tool by insulated gripping surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a
“live” wire may make exposed metal parts of the power tool “live” and could give the operator an
electric shock.
•
Wear a dust mask.
•
Do not use the power tool with a damaged cord. Do not touch the damaged cord and pill the
plug from the outlet when the cord is damaged while working.
Damaged cords increase the risk of
an electric shock.
•
Before beginning work, check the working area (e.g. with a metal detector) to ensure that no
concealed electric cables or gas and water pipes are present.
Contact with electric lines can lead to
fire and electric shock. Damaging a gas line can lead to explosion. Penetrating a water line causes
property damage or may cause an electric shock.
•
In case of damages the replacement of the plug or the supply cord shall always be carried out by the
manufacturer of the tool or his service organization
•
Do not touch the bit during or immediately after operation. The bit becomes very hot during
operation and could cause serious burns.
Technical Data
Machine Type
XP-R30
Rated Voltage
230V~
Frequency 50Hz
Rated input
1100W
No-load speed
600/min
Full-load impact rate
3500/min
Capacity
：
concrete
wood
30mm
30mm
Weight
（
without cord and side handle
）
5.2kg
*Be sure to check the nameplate on product as it is subject to change by areas.
Standard accessories
(1) Plactic case---------------------------------------------------------------------1
(2) Depth gauge--------------------------------------------------------------------1
(3)
Carbon brush
(6*10*14mm)-----------------------------------------------1
(3)
One bottle of grease
30g------------------------------------------------1
Standard accessories are subject to change without notice.
