Redhawk II GSM Modem Users Guide
Draft: 10/30/00
24
Part Number: 07100020 version 00B
© 2000 Xircom, Inc. All rights reserved.
All trademarks and copyrights are the property of Xircom, Inc.
Installation
1.
Unpack Modem
Remove the modem from the shipping box and verify contents with the shipping list.
2.
Mount Modem
The Redhawk II contains the Eagle II radio modem interfaced with a carrier board,
both contained within a protective housing. The applications that the modem is best
suited for, would be those within an enclosed structure, office building or other
facility, where the unit is protected against climatic changes. . The modem must be
installed in a location that meets the environmental requirements for moisture, heat
and cold, for this product.
For mobile, (unattached installations) the modem can be placed on any stable flat
horizontal surface such as a desktop, bookshelf, or window ledge. The risk of
damage to the modem unit, due to being knocked off the surface, or being pulled off
by the cables should be avoided. Power interconnects, RS232 interconnect, and
antenna interconnects should all be performed per detailed instructions found in this
Installation Guide.
For fixed (permanently mounted) applications, the modem can be attached to any flat
surface in any orientation. The installer is responsible to select a surface and fastener
system which will adequately support the weight of the Redhawk II unit, the
interconnect cabling and the antenna (if mounted directly to the Redhawk unit). When
selecting the location and mounting configuration of the Redhawk II unit, the installer
bears the responsibility to assure that all local and national safety codes are met and
should select a location with adequate signal strength to assure consistent GSM
network availability. The installer also shall assure that any security requirements are
met.
Refer to Xircom Drawing Number 06700106, Mechanical Interface Control Drawing, for
size and location of mechanical features including the following:
!
Connector locations
!
Location and size of Redhawk II mounting brackets
!
Recommended mounting fastener sizes for Redhawk II
!
Mounting Fastener Hole Pattern
!
Clearance requirements for installation and removal of SIM card
!
Instruction for installation and removal of SIM card
Note:
All cables which connect to the Redhawk II, should be supported with
strain-relief within 8 inches (200 mm) of the connector interface. The
Redhawk II connectors are not designed to support the weight of cabling
beyond this length. Failure to adequately strain-relief cables may result in
damage to the Redhawk II unit.
3.
Install Antenna
Direct Antenna connection: